If, like us, your weekends are always busy and packed to the brim with other commitments, then you'll know what a struggle it is sometimes to find the necessary time to wash and maintain your car properly. Given this, time-saving products and methods are always worth considering, as long as they don't compromise your standards. Two wash-stage steps where you can safely save a lot of time are wet maintenance and drying off. Using Gyeon Q²M WetCoat adds a significant amount of fresh protection to all exterior surfaces very quickly and easily during the final rinse process, while rinsing off afterwards with pure water obtained using a de-ionising water filter eliminates the need for any towel drying. Gyeon Q²M WetCoat lays down an SiO2-based hydrophobic coating that enhances surface gloss and strongly repels water, dirt and grime. This coating typically endures for up to three months, particularly if you use Gyeon Q²M Bathe+ as your regular shampoo. Do this and you'll never need to quick detail your car again!
|Durability||2 months +|
|Maximum Dwelling Time||2 minutes|
|Recommended For||Coated or sealed finishes|
How To Use
Gyeon Q²M WetCoat comes pre-diluted to the correct strength for safe exterior use, and should be applied to cool, clean, wet surfaces at the end of your usual hand washing process (i.e. after rinsing off the shampoo). For best results, lightly mist Gyeon Q²M WetCoat on to small sections at a time (it's safe for use on all exterior surfaces) and then spread it as thinly and evenly as possible using a fresh wash mitt. After spreading it, allow it to dwell for a maximum of 1-2 minutes before rinsing it off thoroughly (the use of a pressure washer is recommended). Once all sections are treated rinse one final time (to ensure that every last trace of residue is fully removed) and then towel the car dry, or else rinse it again with filtered water if you intend to leave it to dry naturally. As an approximate guide, you should be able to treat an average-sized car using just 75 ml of product; a little goes a very long way when you apply it using the mitt method described above. Finally, note that you should never apply Gyeon Q²M WetCoat in direct sunlight or allow it to dry out before rinsing it off.