Working with coatings can be stressful at times, particularly on extremely soft surfaces that mar very easily. In our experience, there's nothing worse than finally managing to finish down well on soft paint only to then mar it again during the cleansing wipe down. Well, there is one thing worse; getting through the wipe down unscathed only to then mar the finish the during the coating application itself - a few tears are often shed when this happens! However, we're hopeful of never having to experience such frustration again, thanks to Gyeon Q² Primer. Developed specifically to make life easier when preparing delicate paint finishes for quartz coatings, it combines the final polishing and cleansing steps into one and greatly enhances the slickness of treated surfaces. In doing so, it eliminates a significant amount of towel contact with the paint and reduces friction as the coating is subsequently applied, thus greatly reducing the likelihood of fresh marring being inflicted during the process. What more can we say, other than it works brilliantly and makes coating preparatory work much easier.
|Contains Abrasive Particles||Yes (diminishing)|
|Contains Fillers And Glazing Oils||No|
|Suitable For Hand Use||No|
|Suitable For Hard Paints||Yes|
|Suitable For Intermediate Paints||Yes|
|Suitable For Machine Use||Yes|
|Suitable For Soft Paints||Yes|
How To Use
Gyeon Q² Primer should be applied by machine in a dry place out of direct sunlight. For best results using a dual action polisher, Gyeon Q² Primer should be applied to freshly decontaminated and fully corrected paint using a Gyeon Q²M Eccentric Finishing Pad. Only 3-4 pea-sized drops of product are required per 18 x 18 area, and these should be worked in thoroughly at 3000-4000 orbits per minute (speed 3-4 on most dual action polishers) until only a hint of residue remains. This residue should then be buffed off very carefully using a PB Super Buffing Towel. Following application, the car must then be left in a dry place out of direct sunlight for a minimum of 24 hours to allow the SiO2-primed surface to cure before the coating is applied. Alternatively, if waiting this long is not convenient or practical, wipe down the treated surfaces very carefully with Gyeon Q²M Prep in the usual way and then apply the coating immediately afterwards.