The Light versions of Gyeons coatings are no different to their regular coatings, the only difference is they contain the coatings only. These are great for those that don't require the extra bits included. In the case of Q2 One Light, it doesn't contain the Q2M Cure. If you require the full kit, it can be found here: Gyeon Q2 One EVO
As a result of being coated with a smooth, dense layer of crystallized SiO2, treated surfaces become extremely hydrophobic (water-hating), which causes rainfall and rinse water to bead up and roll off very quickly. This extreme beading not only looks good, but also tends to pick up and carry away fresh contaminants, which makes routine washing easier and much safer. In addition to these benefits, Gyeon Q² One EVO Light also provides high levels of protection against bird droppings, bug splatter, road salt and harmful UV radiation for up to twelve months, even on daily drivers (it is virtually impervious to cleaning chemicals and pressure washing). Gyeon Q² One EVO Light is currently supplied as a pre-packed kit containing either a 30 ml or 50 ml bottle of Gyeon Q² One EVO, a Gyeon Q²M Applicator, Stickers and an instruction booklet.
|Application Method||By hand only|
|Emits Strong Fumes||Yes|
|Layerable||Yes (allow 1 hour between coats)|
|Recommended For||All paint types and colours|
How To Use
You should apply Gyeon Q² One EVO Light in a dry place out of direct sunlight. In all cases, prepare the surfaces you are going to treat in the normal way (wash > decontaminate > polish), and then do a wipe down with Gyeon Q²M Prep to ensure that they are spotlessly clean. Next, wrap a Gyeon Q²M Applicator Suedes around a Gyeon Q²M Applicator Block and lightly wet one end of it with Gyeon Q² One using the supplied dropping pipette. Then spread the coating quickly over the first panel, using light pressure and overlapping strokes. After 20-30 seconds, and without adding any more product, rub the Gyeon Q²M Applicator Suede over the panel in tight circles, using moderate speed and pressure. This step is critical, as it levels the coating and makes it easy to remove. You must then buff off the remaining residue as quickly as possible, i.e. before it begins to harden. Buffing off is best accomplished with a PB Super Buffing Towel using moderate speed and pressure in order to fully remove the residue and reveal an intense streak-free shine. Using a bright light, check the panel carefully for smears and remove them before moving on; failure to remove smears fully can result in them hardening to the point of being impossible to remove without machine polishing, so make sure you are thorough!
After all panels are treated you must then leave the car in a dry place out of direct sunlight for a minimum of 24 hours to allow the SiO2 coating to harden (if you wish, you can accelerate this process by heating the treated panels to 60°C for 10 minutes using an infra-red heat lamp). Finally, to reduce the risk of water spots forming while it continues to cure (full curing takes around 14 days to achieve), you should apply a protective topcoat of Gyeon Q²M Cure (you should also avoid washing the car with any kind of detergent for the first 7 days). Please note that you must discard all used applicators and towels after you've applied Gyeon Q² One, because it hardens massively as it cures, forming a residue that has the potential to inflict severe marring or worse if applicators and towels are re-used. Furthermore, after each use you must also replace the dropping pipette with the air-tight cap, and then wash out the pipette with hot water. Failure to follow these steps will result in any leftover product setting solid in the bottle and the pipette, rendering them unusable in the future.