CarPro Hydro2 Snow Sealant
- Foam application
- Cleans and protects
- Water-repellent finish
Wash your car, rinse it clean and leave behind impressive water-repellent protection. HydrO2 Foam combines two jobs into one surprisingly straightforward process.
We love products that make the detailing process more efficient, and CARPRO HydrO2 Foam is a clever example. Rather than washing your car and then applying a separate sealant, this pH-neutral shampoo cleans the paintwork while depositing hydrophobic protection during rinsing. The resulting water behaviour is particularly impressive, with tight beading and noticeably improved water runoff. It's an appealing option when you want a properly washed and protected car without adding another stage to the job.
The important distinction is that this isn't simply a snow foam you spray on and rinse away. CARPRO recommends washing with a mitt after applying the foam, so you're getting proper contact cleaning alongside the protective treatment. For heavily soiled vehicles, we'd still recommend a dedicated pre-wash followed by CARPRO Reset where a more thorough initial clean is needed, rather than expecting HydrO2 Foam to deal with everything on its own.
HydrO2 Foam makes most sense when you want to refresh the finish and add protection during a maintenance wash. If you're happy with your existing shampoo and only want a separate protective treatment, CARPRO HydrO2 Lite is a convenient alternative. Otherwise, the combination of cleaning, gloss and water repellency makes HydrO2 Foam a useful product to have on the shelf.
CARPRO HydrO2 Foam is a pH-neutral automotive shampoo and protective foam developed to wash vehicle surfaces while depositing a hydrophobic silica-based layer. Its formulation combines cleaning surfactants with CARPRO's HydrO2 protection technology, allowing cleaning and surface protection to take place during the same washing process.
HydrO2 Foam produces a rich cleaning foam that helps lift contamination during contact washing. When the vehicle is thoroughly rinsed, the protective ingredients bond to the treated surface, creating a water-repellent finish with enhanced gloss and smoothness. CARPRO describes the resulting protection as resistant to environmental and chemical exposure, with durability of up to three months under suitable conditions.
The product is suitable for compatible hard exterior vehicle surfaces, including paintwork, glass, plastic trim, wheels and wheel arches. It can be applied through a foam lance or diluted in a wash bucket for conventional hand washing.
For foam lance application, CARPRO specifies a dilution of 1:9, followed immediately by contact washing and thorough rinsing. For bucket washing, the manufacturer's recommended dilution is 1:20. Each section should be rinsed immediately after washing to avoid leaving residues on the surface.
HydrO2 Foam should be used on cool surfaces away from direct sunlight. CARPRO warns that applying the product to hot panels or allowing it to dry may cause streaking.
| Application | Foam lance or bucket wash |
|---|---|
| Beading |
|
| Dilution | 1:9 foam lance / 1:20 bucket |
| Durability | Up to 3 months |
| pH | Neutral |
| Protection Type | Silica-based hydrophobic protection |
| Slickness |
|
Work in the shade on cool surfaces. Thoroughly rinse the vehicle to remove loose dirt and grit before beginning the contact wash.
For a foam lance, mix HydrO2 Foam at 1:9 (100ml product with 900ml water) and fully close the foam lance valve as directed by CARPRO. For bucket washing, dilute at 1:20 (approximately 240ml in 4.8 litres of water).
When using a foam lance, apply the foam and immediately begin washing with a clean, suitable wash mitt. For bucket washing, wash one small section at a time using the prepared shampoo solution.
Rinse thoroughly with clean water immediately after washing each section. Do not allow HydrO2 Foam to dry, as this can cause streaking. Continue around the vehicle until all treated areas have been washed and rinsed.
After a final thorough rinse, remove the remaining water using a suitable car dryer or a clean CARPRO DHydrate Drying Towel.
CARPRO HydrO2 Foam is a chemical cleaning and protection product. Avoid contact with eyes and prolonged skin exposure, and wear suitable protective gloves and eye protection when handling the concentrate. Avoid inhaling spray mist and keep out of reach of children.
Use only on cool surfaces away from direct sunlight. Follow the current product label and the Safety Data Sheet for the formulation supplied in the UK for complete hazard classifications, first-aid measures and safe handling requirements.