Aqua Gleam Wall Mounting Clamps

For wall mounting Aqua Gleam water filters. Buy online and earn loyalty points as you shop.
No Stock
How many loyalty points will I earn?

If you have created an account and are signed in, you will earn 1 point per whole £ you spend (e.g. spending £9.50 earns 9 points). The redemption value of each point you earn will vary between £0.05 and £0.15 depending on your rolling annual spend; see our loyalty points page for details.

We Say

Aqua Gleam Wall Mounting Clamps make it easy to use a pair of Aqua Gleam De-ionising Water Filters in tandem via a wall mounted stack, with the upper one acting as a pre-filter for the lower one (when the upper one becomes exhausted you replace it with the lower one and install a brand new one below). This set-up ekes out the usable life of each filter for as long as possible, thus minimising the cost of the system in the long run.

Key Features

Construction PP (Polypropylene)
Diameter 100 mm (Internal)
Pack Size 2 Clamps (Wall Fixings Not Supplied)


Aqua Gleam Wall Mounting Clamps enable an Aqua Gleam De-ionising Water Filter to be wall mounted, thus ensuring that it remains in an upright position during use (which optimises its performance). The clamps are constructed from heavy duty polypropylene and are easy to affix to most types of walls (please note that fixings are not supplied; you will need to buy these separately from a DIY store).


More Information
Construction Polypropylene
Dimensions ⌀ 100 mm (clamp diameter)

How To Use

Aqua Gleam Wall Mounting Clamps should be fitted in line with the instructions supplied with the Aqua Gleam De-ionising Water Filter. It's wise to mount your filter (or filter stack) in a place where it can drain freely after use and where it's protected from both sunlight and frost (if you have no choice but to mount your filter (or filter stack) in a sunny position try to remember to cover it with a towel in between uses).


Close Close