PA Foam Lance Parts & Accessories

Murphy's Law dictates that (i) no sooner will you have purchased a shiny new PA Foam Lance when your pressure washer will decide to pack up; and (ii) a deal too good to miss will be on offer on another make of pressure washer, making the original fitment on your shiny new PA Foam Lance redundant. C'est la vie, but not to worry, as now you can buy replacement fitments separately! In addition, accidents can happen, and if you are unlucky enough to drop your lance and break the bottle you can now buy a replacement bottle at minimal cost.

PA Foam Lance Parts & Accessories are built to last. With the exception of the two Karcher options, all of the replacement fitments and extension pipes are constructed from solid brass and stainless steel respectively, giving them excellent long-lasting performance and durability (the two Karcher options and the replacement bottle are made of impact resistant nylon and translucent high-density polyethylene respectively).

Replace existing fitments as follows. Using smooth faced spanners or grips, hold the injector head still, loosen the fitment connection and then remove the old fitment carefully. Then gently remove any traces of old PTFE tape from the female thread in the injector head, taking care not to damage the thread in any way. Next, wind half a dozen loops of PTFE tape tightly around the male thread on the replacement fitment. Then carefully begin to screw this into the female thread in the injector head by hand and, when you are fully sure the threads have mated properly, do up the connection tightly using smooth faced spanners or grips.