Over the last five years we have tested more than a dozen pre-wash foaming agents from various different suppliers and, with the exception of the recently released Auto Finesse Avalanche, none have come close to offering the same all round level of performance as Meguiar's Hyper Wash. Frequently overlooked as a pre-wash foam product simply because it doesn't have the term snow foam in its name, Meguiar's Hyper Wash is in fact a long proven leader in this field. In one fell swoop it offers: (i) a highly economical dilution rate and thus excellent value for money; (ii) excellent performance in terms of balancing outright cleaning strength with the need to preserve protective sealant and wax coatings, and; (iii) a fully biodegradable formula that is friendly to the environment. In a word, it's brilliant, and comes highly recommended if a gentle foaming action is desired.
Meguiar's Hyper Wash makes typical dilution rates for pre-wash foam products look incredibly wasteful. Meguiar's have created a pre-wash foaming agent that produces rich stable foam at an unbelievable dilution rate of just 400:1 (water:product). The biodegradable formula safely and effectively lifts dirt and grime off all exterior surfaces without stripping sealant or wax protection, and can also be used as a normal car wash shampoo as and when the need arises.
Meguiar’s Hyper Wash is suitable for use in any foam gun or foam lance system, providing that a dilution ratio of approximately 400:1 (water:product) can be achieved. With regard to the systems that we offer, the following advice applies: (i) for use in conjunction with a PB Foam Gun, remove the bottle lid and pour or pump approximately 200 ml of Meguiar’s Hyper Wash into the bottom of the bottle, then fill the bottle to the top with hot water, refit the bottle lid and shake gently to mix the solution before finally attaching the foam gun your hose - then squeeze the trigger and adjust the top dial on the bottle lid until you get the desired foam thickness; (ii) for use in conjunction with a PA Foam Lance, remove the injector head and pour or pump approximately 100 ml of Meguiar’s Hyper Wash into the bottom of the bottle, then fill the bottle to the top with hot water, refit the injector head and shake the gently to mix the solution before finally attaching it to your pressure washer - then fire the washer up, and adjust the top dial on the injector head until you get the desired foam thickness.
|Strips sealants and waxes:|
|Suitable for pre-wash foaming:|
|Light cleaning action:|
|Recommended dilution ratio:||400:1 (water:product)|