If, like us, your weekends are always busy and packed to the brim with other commitments, you'll know what a struggle it is sometimes to find the necessary time to wash and maintain your car(s) properly. Therefore, time-saving products and methods are always worth considering, so long as they don't compromise your standards. Two wash-stage steps where you can safely save a lot of time are wet maintenance and drying off. Using GYEON Q2M WETCOAT adds a significant amount of fresh protection to all exterior surfaces very quickly and easily during the final rinse process, while rinsing off afterwards with pure water obtained using an Aqua Gleam 350 mm De-ionising Water Filter eliminates the need for any drying off. GYEON Q2M WETCOAT lays down an SiO2-based hydrophobic coating that enhances surface gloss and strongly repels water, dirt and grime. This coating typically endures for up to three months, particularly if you use GYEON Q2M BATHE+ as your regular shampoo. Do this and you'll never need to quick detail your car again!
GYEON Q2M WETCOAT is a spray-on, rinse-off, silica-based coating designed to be applied after hand washing but before drying off, i.e. during the final rinse process. As a direct result of being treated with GYEON Q2M WETCOAT, exterior surfaces become more radiant looking and extremely hydrophobic. The latter effect is the most pronounced, not only in relation to the sudden dramatic improvement in water beading it causes, but also in terms of the self-cleaning properties it imparts (by actively repelling rain and road spray, more dirt and grime is carried away instead of being allowed to accumulate in situ). Consequently, GYEON Q2M WETCOAT makes routine maintenance quicker and easier, as the interval between washes can be comfortably extended, and the need for quick detailing is eliminated. These benefits apply all year round, but are particularly welcome during the winter months, when washing becomes more of a chore. Durability is up to three months, or twelve washes if you clean your car more frequently than once a week.
GYEON Q2M WETCOAT comes pre-diluted to the correct strength for safe exterior use, and should be applied to cool, clean, wet surfaces at the end of your usual hand washing process. For best results, lightly mist GYEON Q2M WETCOAT onto small sections at a time (it’s safe for use on all exterior surfaces) and then spread it as thinly and evenly as possible using a fresh wash mitt. After spreading it, allow it to dwell for a maximum of 1-2 minutes before rinsing it off thoroughly (the use of a pressure washer is recommended). Once all sections are treated rinse one final time (to ensure that every last trace of residue is fully removed) and then towel the car dry, or else rinse it again with filtered water if you intend to leave it to dry naturally. As an approximate guide, you should be able to treat an average-sized car using just 75 ml of product; a little goes a very long way when you apply it using the mitt method described above. Finally, note that you should never apply GYEON Q2M WETCOAT in direct sunlight or allow it to dry out before rinsing it off.
|Durability:||3 months, or 12 washes|
|Recommended for:||Topping up protection on all exterior surfaces|