Is GYEON Q2M FOAM the thickest, best performing, snow foam ever? Quite possibly yes! It's no secret that this product has taken GYEON a long time to develop and perfect; despite pressure from the detailing community to release it as soon as possible, GYEON held their nerve and continued to test and revise the formula until they could improve it no further. And, based on our initial tests with it, this effort has paid off. Firstly, how well does it foam up? The answer is better than any other snow foam we've ever used (assuming that the correct dilution ratio/range is adhered to), and this does not appear to be affected by water hardness (which cannot be said for rival products, which tend to produce slightly less foam in hard water areas). GYEON Q2M FOAM produces a ridiculous amount of thick clinging foam, which is great, because this maximises its dwelling time, even on slick well protected finishes. Secondly, how well does it clean? The answer is very well. During our initial tests, we called upon it to remove four weeks' worth of salty winter grime without any help from a pre-wash grime remover, and it did very well. Sure, the usual grimy film remained afterwards (that only a mitt wash would fully remove), but the main bulk of the dirt and grime was completely gone. As such, it's every bit as good as its main rival, Auto Finesse Avalanche, but offers marginally better foaming performance in hard water areas. All in all, GYEON Q2M FOAM is another stellar addition to the awesome GYEON line up.
GYEON Q2M FOAM is a highly concentrated snow foam designed to dissolve and lift away a high proportion of dirt and grime in a completely touchless fashion. Although best suited to regular use and tackling relatively fresh contaminants, it is also powerful enough to tackle more persistent road films that have gone through multiple wetting and drying cycles and become more firmly bonded. The main ingredient in GYEON Q2M FOAM is a powerful blend of non-caustic surfactants that safely loosen the bond between dirt and underlying surfaces without stripping or otherwise degrading previously coated surfaces. Fast acting and safe for use on all exterior automotive surfaces, GYEON Q2M FOAM also rinses away easily and completely to leave such surfaces looking clean and streak free. This is critical on vehicles protected with silica-based coatings, as detergent residues can otherwise diminish their inherent and hugely beneficial self-cleaning properties. When properly diluted, GYEON Q2M FOAM is completely safe for use on all exterior automotive surfaces, including sensitive materials such as polished aluminium. Because it is highly concentrated, GYEON Q2M FOAM offers a degree of latitude with respect to its effective dilution rate. During the summer months, as little as 50 ml is needed (in the bottle of a PA Foam Lance) to remove dust and pollen, whereas in the winter months up to 200 ml can be used (in the bottle of a PA Foam Lance) to tackle thick salty grime.
GYEON Q2M FOAM is suitable for use in any foam gun or foam lance system, providing that a final dilution ratio of approximately 100:1 (water:product) can be achieved. With regard to the systems that we offer, the following advice applies: (i) for use in conjunction with a PB Foam Gun, remove the bottle lid and pour or pump approximately 200 ml of GYEON Q2M FOAM into the bottom of the bottle, then fill the bottle to the top with hot water, refit the bottle lid and shake gently to mix the solution before finally attaching the foam gun your hose - then squeeze the trigger and adjust the top dial on the bottle lid until you get the desired foam thickness; (ii) for use in conjunction with a PA Foam Lance, remove the injector head and pour or pump approximately 100 ml of GYEON Q2M FOAM into the bottom of the bottle, then fill the bottle to the top with hot water, refit the injector head and shake the whole assembly gently to mix the solution before finally attaching it to your pressure washer - then fire the washer up, and adjust the top dial on the injector head until you get the desired foam thickness. In both examples given above, you can safely double the amount of GYEON Q2M FOAM used when tackling particularly dirty cars, or else halve it if only a light clean is needed.
|Strips sealants and waxes:|
|Suitable for pre-wash foaming:|
|Intensive cleaning action:|
|Recommended dilution ratio:||100:1 (water:product)|