GYEON Q2 TRIM is an advanced quartz coating specifically formulated to protect exterior plastics against UV radiation and oxidation. Developed in South Korea, GYEON Q2 TRIM uses the latest in low volatile content silicon (Si) technology to lay down a film of siloxane polymers and elastic bonding agents that condense rapidly to form a flexible SiO2 coating that bonds to plastic surfaces at the molecular level. Unlike rival nanotechnology products, GYEON Q2 TRIM contains no alcohol and therefore doesn't flash off rapidly, which makes the application process easier. Thanks to its unique formula, it also does an excellent job of darkening down faded trims and masking other signs of age, and imparts a beautiful satin looking finish that does not run or streak when it gets wet.
As a result of being coated with a smooth, dense layer of flexible SiO2, treated surfaces become naturally water hating (hydrophobic), which causes rainfall and rinse water to bead up and roll off very quickly. This extreme beading not only looks good, but also tends to pick up and carry away fresh contaminants, which ensures that treated trims and light clusters stay cleaner for longer. In addition to these benefits, GYEON Q2 TRIM also provides excellent protection against UV radiation and oxidation for up to twelve months at a time, even daily drivers, making it a far more appealing and cost effective proposition than traditional trim dressings. Like its siblings in the GYEON Q2 range, it too is virtually impervious to strong cleaning chemicals and pressure washing.
This set comprises...
1 x GYEON Q2 TRIM (30 ml)
1 x GYEON Q2M APPLICATOR SET
1 x Instruction Manual
You should apply GYEON Q2 TRIM in a dry place out of direct sunlight. In all cases, prepare the trims you are going to treat in the normal way (wash > decontaminate), and then do a wipe down with GYEON Q2M PREP to ensure that they are spotlessly clean. Next, using the supplied dropping pipette, lightly wet one of the supplied suede applicators with the product and begin wiping it evenly onto the trims, using light pressure and overlapping strokes (cut the applicator down to size if necessary). You should be able to treat all of the trims on the car in one go, because GYEON Q2 TRIM stays wet for 10-15 minutes following application. Once all of the trims are treated, go back around the car buffing them off gently with a PB Super Buffing Towel, in order to remove any excess product and even out the finish before the coating dries fully.
The car must then be left somewhere warm and dry for a minimum of 12 hours to allow the SiO2 coating to harden (if you wish, you can accelerate this process by heating the treated trims to 60°C for 10 minutes using an infra-red heat lamp). To reduce the risk of water spots forming while it continues to cure (full curing takes around 14 days to achieve), you should apply a protective top coat of GYEON Q2M CURE (you should also avoid washing the trims with any kind of detergent for the first 7 days). Please note that you must discard all used applicators and towels after you've applied each coat, because GYEON Q2 TRIM hardens a lot as it cures, forming a residue that has the potential to inflict severe marring or worse if applicators and towels are re-used. Furthermore, after each use you must also replace the dropping pipette with the air-tight cap, and then wash out the pipette with hot water. Failure to follow these steps will result in any leftover product setting solid in the bottle and the pipette, rendering it unusable in the future.
|Durability:||9 months +|