Working with coatings can be stressful at times, particularly on extremely soft surfaces that mar very easily. In our experience, there's nothing worse than finally managing to finish down well on soft paint only to then mar it again during the cleansing wipe down. Well, there is one thing worse; getting through the wipe down unscathed only to then mar the finish during the coating application itself - a few tears are often shed when this happens! However, we're hopeful of never having to experience such frustration again, thanks to GYEON Q2 PRIMER. Developed specifically to make life easier when preparing delicate paint finishes for coatings, it combines the final polishing and cleansing steps into one and greatly enhances the slickness of treated surfaces. In doing so, it eliminates a significant amount of towel contact with the paint and reduces friction as the coating is subsequently applied, thus greatly reducing the likelihood of fresh marring being inflicted during the process. What more can we say, other than it works brilliantly and makes coating preparatory work far easier.
GYEON Q2 PRIMER is an ultra-fine finishing polish and SiO2-based primer for quartz coatings. It is designed to burnish painted surfaces to perfection and prepare them to receive a silica-based coating without the need for a subsequent cleansing step. Although it is suitable for use on all paint types, it excels on extremely soft finishes that are difficult to prepare and coat without introducing fresh marring. It achieves this by eliminating unnecessary wiping down of the freshly polished finish and significantly enhancing the slickness of treated surfaces, which reduces friction when the coating is subsequently applied. Comprising a unique blend of ultra-fine precision-milled diminishing abrasives and siloxane polymers suspended in a water-based emulsion, GYEON Q2 PRIMER offers enormous advantages in terms of extremely low dust production, incomparable finish quality and reduced marring risk. Free of silicones and fillers, it works best with soft foam finishing pads and performs equally well whether used in conjunction with dual action or rotary machine polishers.
You should apply GYEON Q2 PRIMER with a machine in a dry place out of direct sunlight. For best results using a dual action polisher, apply GYEON Q2 PRIMER with a Lake Country 140 mm Hydro-Tech Finishing Pad. Only 3-4 pea-sized drops of product are required per 18" x 18" area. After spreading, work it thoroughly at 3000-4000 orbits per minute (speed 3-4 on most dual action polishers) until only a hint of residue remains. Buff off this residue carefully using a PB Super Buffing Towel. For best results using a rotary polisher, apply GYEON Q2 PRIMER with a Lake Country 140 mm Rotary H-T Finishing Pad. Only 1-2 pea-sized drops of product are required per 18" x 18" area. After spreading, work it thoroughly at 1000-1500 revolutions per minute (speed 2-3 on most rotary polishers) using the zenith method until only a hint of residue remains. Buff off this residue carefully using a PB Super Buffing Towel. Following application, the car must then be left in a dry place out of direct sunlight for a minimum of 24 hours to allow the SiO2-primed surface to cure before the coating is applied. Alternatively, if you cannot afford to wait this long, wipe down the treated surfaces with GYEON Q2M PREP in the usual way and then apply the coating immediately afterwards.
|Suitable for hand use:|
|Suitable for dual action polishers:|
|Suitable for rotary polishers:|
|Suitable for soft paints:|
|Suitable for intermediate paints:|
|Suitable for hard paints:|
|Contains abrasive particles:|
|Diminishing type abrasives:|
|Contains chemical cleaners:|
|Contains fillers and glazing oils:|