Foggy windows arise when dampness brought into your car on your clothes condenses out on glass surfaces that are colder than the air in your car (as the warmer air gives up some of its heat to the windows it loses its ability to hold as much water vapour, meaning that some of it downgrades into liquid form on the cooler glass surfaces). GYEON Q2 ANTIFOG is a special glass coating containing hydrophilic, i.e. water-loving, ingredients. These ingredients attract and absorb water, spreading it evenly over the surface of the coating and thus helping to prevent freshly forming water droplets from becoming large enough to be visible (this is, in essence, how most anti-fog coatings work).
In extreme cases, when so much moisture is absorbed that saturation occurs, a high degree of visibility is still maintained compared to that associated with fogginess on untreated windows. GYEON Q2 ANTIFOG therefore improves driving comfort and safety in poor weather conditions, particularly during the winter months when foggy windows tend to become more of an issue for many drivers (you should use it in conjunction with GYEON Q2 VIEW on the exterior windows for maximum effectiveness). Of course, such wetting episodes will progressively degrade the coating and ultimately wash it away completely, necessitating its reapplication every couple of months or so.
This set comprises...
1 x GYEON Q2 ANTIFOG (120 ml)
1 x GYEON Q2M APPLICATOR SET
1 x Instruction Manual
GYEON Q2 ANTIFOG should be applied in dry conditions out of direct sunlight. To achieve the quoted durability and performance benefits it is necessary to properly clean the surfaces to be treated in advance. To do this, use a good quality glass cleaner such as 3M Glass Cleaner or Auto Finesse Crystal to remove any obvious dirt and fingerprints and then immediately follow up with GYEON Q2M PREP to remove any lingering traces of residual grease and grime (put simply, the cleaner the glass is before the coating is applied, the better the coating will perform).
Before applying the coating, shake the bottle vigorously to ensure that the contents are fully mixed. Next, soak one of the supplied suede applicators with the product and work it in to the surfaces to be treated in a circular fashion, using firm pressure. The resulting film should be left to dry for a minimum of 5 minutes before being buffed off with a PB Utility Towel, so we recommend treating several windows at a time. Note that if you buff too soon a haze may appear; if this happens leave the coating to dry for a further 15 minutes before buffing it off again.
|Safe for window tints:|
|Suitable for interior use:|
|Suitable for exterior use:|
|Emits strong fumes:|
|Application method:||By hand only|
|Durability:||2 months +|