Blackfire Wet Diamond Kit

Blackfire All Finish Paint Protection is one of the very best synthetic paint sealants on the market today, and is used frequently in our studio. Incredibly easy to apply and remove, it delivers a jaw dropping finish characterised by pin-sharp reflectivity, excellent flake pop and a truly liquid-like level of glossiness that makes paint look literally like a wet diamond. Like most synthetic polymer-based sealants, it falls down a little bit in terms of richness and beading strength, but more than makes up for this in terms of slickness and durability; in our experience, a lifespan of between three to four months per application on a daily driver is easily achievable. The foundation stone of the wet diamond finish is an initial application of Blackfire Gloss Enhancing Polish, which masks minor paint defects (such as wash marring and fine swirl marks) and dramatically enhances surface gloss in order to create the illusion that the paint is dripping wet.

Blackfire All Finish Paint Protection is a paint-friendly, water-based sealant formulated with the latest generation of crystal super-polymers. Incredibly easy to apply and remove, this synthetic sealant locks in the finish created by Blackfire Gloss Enhancing Polish and delivers a jaw dropping finish characterised by pin-sharp reflectivity, excellent flake pop and a truly liquid-like level of glossiness. Maintenance of the wet diamond finish is easily performed using Blackfire Deep Gloss Spray Sealant. This quick detailing spray contains the same crystal super-polymers used in the rest of the system and can be used repeatedly to enhance gloss and extend protection without any fear of causing hazing or streaking. In fact, regular use is recommended, as it will greatly enhance surface slickness, making washing and drying even easier and prolonging the life of the underlying protective sealant and wax layers indefinitely.

Step 1 – Blackfire Gloss Enhancing Polish

Blackfire Gloss Enhancing Polish should be applied to freshly clayed paint using the supplied Meguiar’s Microfibre Applicator Pad. Only 3-4 pea-sized drops of product are required per panel and these should be wiped in as thinly and evenly as possible to produce a film that should then be allowed to dry for up to 15 minutes. Once hazed over, this film should then be buffed off carefully using the supplied Poorboy’s Super Thick & Plush Towel.

Step 2 – Blackfire All Finish Paint Protection

Blackfire All Finish Paint Protection should be applied using the supplied Blackfire Ultimate Applicator Pad. Only 2-3 pea-sized drops of product are required per panel and these should be applied as thinly and evenly as possible to produce a film that should then be allowed to cure for up to 15 minutes. Once hazed over, this film should then be buffed off carefully using one of the supplied Poorboy’s Deluxe Mega Towels.

Step 3 – Blackfire Deep Gloss Spray Sealant

Lightly mist Blackfire Deep Gloss Spray Sealant over a single panel at a time, and immediately wipe the panel down to spread a thin, even film of product using one of the supplied Poorboy’s Deluxe Mega Towels. Then refold your towel, and buff the panel down carefully to fully remove the film and reveal an intense streak-free shine.

Care instructions for applicators and towels

(i) wash after each use in a washing machine at a low temperature (40 °C) using a non-biological liquid detergent (avoid soap powders and detergents containing bleach or fabric softeners); (ii) allow to dry naturally on a line or tumble dry on a cool heat setting (avoid radiators and other sources of high heat), and; (iii) store in a dry, dust-free environment whilst not in use (lidded plastic storage boxes are ideal in this respect).